Q. Modulated carrier power in FM

View solution

Q. FM receivers using the standard 88 to 108 MHz band use IF of

View solution

Q. Most of the amplification of the received signal is obtained in a superheterodyne receiver from the

View solution

Q. The problem associated with tuned-radio frequency receiver is

View solution

Q. Which of the following noise becomes of great importance at high frequencies?

View solution

Q. Superheterodyne receiver can be used in

View solution

Q. Which of the following statement about the advantage of phase discriminator over the slope detector is false?

View solution

Q. Fidelity of a receiver represents

View solution

Q. Which of the following produces upper and lower side frequencies?

View solution

Q. The passband of the tuned circuits of a radio receiver should be equal to

View solution

Q. In a receiver, at higher frequencies

View solution

Q. Which of the following circuit cannot be used to demodulate SSB?

View solution

Q. High IF in a superheat receiver

View solution

Q. The typical squelch circuit

View solution

Q. A communication channel with additive white Gaussian noise, has a bandwidth of 4 kHz and an SNR of 15. Its channel capacity is

View solution

Q. In a superheterodyne receiver, the IF stage has better selectivity than RF stage because

View solution

Q. An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is

View solution

Q. The purpose of incorporating a pre-selector stage in a receiver is to

View solution

Q. Vividh Bharati programme is transmitted in

View solution

Q. The image frequency of a superheterodyne receiver is

View solution