Question

Fidelity of a receiver represents

a.

the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output

b.

the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies

c.

the variation of the output with the modulation frequency when the output impedance is a resistance

d.

none of the above

Posted under Electronics and Communication Engineering

Answer: (c).the variation of the output with the modulation frequency when the output impedance is a resistance

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Fidelity of a receiver represents
Add Comment

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Which of the following produces upper and lower side frequencies?

View solution

Q. The passband of the tuned circuits of a radio receiver should be equal to

View solution

Q. In a receiver, at higher frequencies

View solution

Q. Which of the following circuit cannot be used to demodulate SSB?

View solution

Q. High IF in a superheat receiver

View solution

Q. The typical squelch circuit

View solution

Q. A communication channel with additive white Gaussian noise, has a bandwidth of 4 kHz and an SNR of 15. Its channel capacity is

View solution

Q. In a superheterodyne receiver, the IF stage has better selectivity than RF stage because

View solution

Q. An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is

View solution

Q. The purpose of incorporating a pre-selector stage in a receiver is to

View solution

Q. Vividh Bharati programme is transmitted in

View solution

Q. The image frequency of a superheterodyne receiver is

View solution

Q. Noise limiter is provided on AM receivers to

View solution

Q. A low ratio of the A.C. load impedance of a diode detector results in

View solution

Q. A trimmer is basically a

View solution

Q. In a radio receiver

View solution

Q. The sensitivity of a superheterodyne receiver is determined by

View solution

Q. In a radio receiver

View solution

Q. In radio receiver, the maximum contribution to noise is from

View solution

Q. Power spectral density of white noise

View solution
View All MCQs on Electronics and Communication Engineering

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!

Concrete Technology

Welcome to Concrete Technology, a category that unravels the secrets behind the...

Basic Electrical Engineering

Master the fundamentals of Electrical Engineering with our specialized category....

Food Engineering

Explore the fascinating world of Food Engineering with our specialized category....

UIDAI Aadhaar Supervisor Certification

Prepare for the UIDAI Aadhaar Supervisor Certification with our specialized category....

Professional Communication

Hone your communication skills with our Professional Communication category. Enhance...

IC22 Life Insurance Underwriting

Prepare for success in the Insurance Institute of India (III) examination with IC22...

IC38 Life Insurance Agent Exam

Prepare for success in the Insurance Institute of India (III) IC38 IRDA examination...

Mechanics of Materials

Unlock the principles of Mechanics of Materials with our specialized category. Dive...

Total Quality Management

Enhance your understanding of quality management with our Total Quality Management...