Question

The component in the given figure is

a.

attenuator

b.

T type low pass filter

c.

T type high pass filter

d.

phase shifter

Answer: (b).T type low pass filter

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The component in the given figure is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In the given figure the reflected current wave after first reflection is

Q. In a microwave coaxial line, the maximum operating frequency is f max and breakdown strength of dielectric is Ed' Then maximum power handling capacity is proportional to

Q. In the given figure the E and H lines in a coaxial cable

Q. When a line is loaded the characteristic impedance is equal to

Q. In the given figure forward current wave has a magnitude of

Q. In the given figure shows the equivalent circuit of a magic tee. If all ports are matched

Q. In the given figure forward voltage wave has a magnitude

Q. For a rectangular waveguide having width a and height b, the cutoff wavelength for TM₁₁ mode is equal to

Q. If ZTE is wave impedance for TE waves, Ed is maximum dielectric strength of insulating material, a and b are the width and height of a rectangular wave guide, the maximum power handling capability Pmax for TE₁₀ mode is

Q. In the given figure a short circuited transmission line resonator If n = 1, 2, 3...

Q. The Q factor of a waveguide resonator is given by (ω0 is resonant frequency, U is energy storage and WL is the power loss)

Q. For l << λ, the equivalent circuit of a microwave resistor is

Q. If μr is relative permeability, ∈r is relative permittivity, c is velocity of light fc is cutoff frequency, phase velocity vp (i.e., speed with which a particular phase of the wave travels down a rectangular waveguide at frequency f) is given by

Q. A square waveguide carries TE₁₁ mode whose axial magnetic field is given by following equation, where the guide dimensions are in cms. The cut off frequency of the mode is

Q. In the given figure shows a 10dB directional coupler. If power input at port 1 is 100 mW, power output at port 3 is

Q. In the given figure the line voltage after a number of reflections will be

Q. In directional coupler of the given figure, the terms |S₁₄| and |S₂₃| of scattering matrix are nearly

Q. A 3 port circulator is in the given figure. Its scattering matrix is

Q. If ρv is reflection coefficient and VSWR is voltage standing wave ratio, then

Q. In terms of R, L, G and C the propagation constant γ of a transmission line is

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!