Question
a.
IC and VCB
b.
IE and VCB
c.
IC and VCE
d.
IE and VCE
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In CE configuration, the output characteristics of a bipolar junction transistor is drawn between
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Assertion (A): The reverse current in a p-n junction is nearly constant.
Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.
View solution
Q. An n type semiconductor is illuminated by a steady flux of photons with energy greater than the band gap energy. The change in conductivity Δσ obeys which relation?
[ Here, e is the electron charge, μn electron mobility, μp hole mobility, Δn (Δp) is the excess electron (hole) density ].
View solution
Q. The band gap of Si at room temperature is
View solution
Q. Spot the odd one out
View solution
Q. Transition capacitance is associated with __________ and depletion capacitance is associated with __________ diodes.
View solution
Q. If the energy gap of a semiconductor is 1.1 eV, then it would be.
View solution
Q. The maximum rectification efficiency in case of full wave rectifier is
View solution
Q. For a full wave bridge rectifier supplied with 50 Hz a.c., the lowest ripple frequency will be
View solution
Q. When an electron rises through a potential of 100 V it will acquired an energy of
View solution
Q. Which one of the following gain equations is correct for a MOSFET common-source amplifier?
(gm is mutual conductance, and RD is load resistance at the drain)
View solution
Q. If 1 kVA transformer is used for all of the following rectifiers, the d.c. power availability will be least in case of
View solution
Q. In which of the following does a negative resistance region exist in the v-i characteristics?
View solution
Q. The intrinsic resistivity of silicon at 300 K is about
View solution
Q. What happens when forward bias is applied to a junction diode?
View solution
Q. A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.
View solution
Q. The addition of impurity in extrinsic semiconductor is about 1 part in 10⁸ parts.
View solution
Q. It is required to trace the output characteristics of a CE bipolar transistor on a CRO screen. The proper method is
View solution
Q. Atomic number of germanium is
View solution
Q. The resistivity of ferrites is
View solution
Q. A JFET
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
