Question
1. The former has higher input impedance than the later
2. The former has higher frequency stability than the later
3. The later has lower noise figure than the former
4. The later has higher power rating than the former
Of these statements
a.
1 and 2 are correct
b.
2 and 3 are correct
c.
3 and 4 are correct
d.
1 and 4 are correct
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Consider the following statement associated with bipolar junction transistor and JFET 1. The former has higher input impedance than the later 2. The former has higher...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The turn off time of a bipolar transistor is about
View solution
Q. Hystresis loss least depends on
View solution
Q. In a bipolar transistor, emitter efficiency is about
View solution
Q. For signal diodes the PIV rating is usually in the range
View solution
Q. The potential of suppressor grid (with respect to cathode) is usually
View solution
Q. Photoelectric effect occurs only in semiconductors and not in metals.
View solution
Q. Which of these has peak and valley points in v-i curve?
View solution
Q. The scaling factor of an MOS device using constant voltage scaling model, the gate area of the device will be scaled as
View solution
Q. A full wave bridge rectifier is supplied voltage at 50 Hz. The lowest ripple frequency will be
View solution
Q. The output characteristics of a bipolar transistor has three distinct regions. They are known as
View solution
Q. Assertion (A): In a BJT, αdc is about 0.98.
Reason (R): In a BJT, recombination in base region is high.
View solution
Q. Wienbridge oscillator uses
View solution
Q. Which of the following material is preferred for transformer cores operating in micro wave frequency range?
View solution
Q. The ac resistance of a forward biased p-n junction diode operating at a bias voltage V and carrying current 'I' is
View solution
Q. As the temperature of an intrinsic semiconductor material is increased
View solution
Q. In an insulated gate FET, the polarity of inversion layer is the same as that of
View solution
Q. Hall effect can be used to find the type of semiconductor.
View solution
Q. The conductivity of germanium increases by about 6 percent per degree increase in temperature.
View solution
Q. The range of visible light is
View solution
Q. Which of the following materials has the highest electrical conductivity?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
