Q. Assertion (A): When a zener diode breakdown, occurs the voltage across it is constant.

Reason (R): The upper limit of zener current is determined by power handling capacity.

View solution

Q. Consider the following statements

1. An iron cored choke is a nonlinear device.
2. A carbon resistor kept in a sunlight is a time - invariant and passive device.
3. A dry cell is a time - varying and active device.
4. An air capacitor is a time - invariant and passive device

Of these statements

View solution

Q. If 10 V is the peak voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit), then the maximum voltage on the reverse biased diode will be

View solution

Q. In energy band diagram of p type semiconductor the acceptor energy level is

View solution

Q. Given a power supply filter circuit, what measurements must be made of determine percentage regulation

View solution

Q. When the gate terminal of MOSFET is positive, it is said to operate in

View solution

Q. Assertion (A): In a Schottky diode the reverse recovery time is almost zero.

Reason (R): A Schottky diode has aluminium silicon junction.

View solution

Q. The drain characteristics of JFET are drawn between

View solution

Q. Electrical contact materials used in switches, brushes and relays must possess

View solution

Q. A JFET behaves as a constant current source when

View solution

Q. The electron and hole concentration in a intrinsic semiconductor are ni and Pi respectively when doped with a P type material, these change to n and P, respectively. Then

View solution

Q. The energy to cause thermionic emission is supplied by heating the cathode.

View solution

Q. Assertion (A): In an n-p-n transistor as the electrons enter the collector region, they are accelerated towards the collector terminal.

Reason (R): Emitter base junction in BJT is forward biased.

View solution

Q. Assertion (A): In reverse biased p-n junction, the reverse saturation current is nearly constant if the reverse voltage is less than critical value.

Reason (R): The total reverse current is sum of reverse saturation current and surface leakage current.

View solution

Q. The mass of an electron is nearly

View solution

Q. The cut in voltage

View solution

Q. With an ac input from 50 Hz power line, the ripple frequency is

View solution

Q. For an insulating material, dielectric strength and dielectric loss should be respectively

View solution

Q. Semiconductors have

View solution

Q. The I/P impedance (Zi) and the O/P impedance (Zo) of an ideal trans conductance (Voltage controlled current source) amplifier are

View solution