Question
a.
high thermal conductivity and high melting point
b.
low thermal conductivity and low melting point
c.
high thermal conductivity and low melting point
d.
low thermal conductivity and high melting point
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Electrical contact materials used in switches, brushes and relays must possess
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A JFET behaves as a constant current source when
View solution
Q. The electron and hole concentration in a intrinsic semiconductor are ni and Pi respectively when doped with a P type material, these change to n and P, respectively. Then
View solution
Q. The energy to cause thermionic emission is supplied by heating the cathode.
View solution
Q. Assertion (A): In an n-p-n transistor as the electrons enter the collector region, they are accelerated towards the collector terminal.
Reason (R): Emitter base junction in BJT is forward biased.
View solution
Q. Assertion (A): In reverse biased p-n junction, the reverse saturation current is nearly constant if the reverse voltage is less than critical value.
Reason (R): The total reverse current is sum of reverse saturation current and surface leakage current.
View solution
Q. The mass of an electron is nearly
View solution
Q. The cut in voltage
View solution
Q. With an ac input from 50 Hz power line, the ripple frequency is
View solution
Q. For an insulating material, dielectric strength and dielectric loss should be respectively
View solution
Q. Semiconductors have
View solution
Q. The I/P impedance (Zi) and the O/P impedance (Zo) of an ideal trans conductance (Voltage controlled current source) amplifier are
View solution
Q. The relation between thermionic emission current and temperature is known as
View solution
Q. Assertion (A): When forward biased a p-n junction has low resistance.
Reason (R): The ratio dv/di is called dynamic resistance.
View solution
Q. Assertion (A): JFET is a voltage controlled device.
Reason (R): The drain current can be controlled by controlling VGS.
View solution
Q. For a P-N junction diode, the current in reverse bias may be
View solution
Q. An amplifier with resistive -ve feedback has two left poles in its open loop transfer function. The amplifier
View solution
Q. Amplification of ultrasonic waves is possible in a piezoelectric semiconductor under applied electric field. The basic phenomenon involved is known as
View solution
Q. For a junction FET in the pinch off region, as the drain voltage is increased, the drain current
View solution
Q. For a BJT, under the saturation region.
View solution
Q. In which mode of BJT operation are both junctions reverse biased?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
