Q. Two thyristor of same rating and same specifications

View solution

Q. The amount of dielectric heating is inversely proportional to frequency.

View solution

Q. A semiconverter feeding an RLE load operates in

View solution

Q. The phenomenon of overlap in converter operation due to

View solution

Q. A thyristor has a maximum allowable junction temperature of 120°C and the ambient temperature is 40°C. If thermal resistance is 1.6° C/W, the maximum allowable internal power dissipation is

View solution

Q. For a 12 pulse operation, the two 6 pulse units are fed by

View solution

Q. In a single phase full wave converter (M - 2 connection) feeding a highly inductive load, the firing angle for each thyristor is a in the respective half cycle. The period of conduction of each thyristor is

View solution

Q. If Vdc1 is the dc output voltage in half wave controlled rectifier circuit feeding resistive load and Vdc2 is the dc output voltage in full wave controlled rectifier circuit (M - 2 connection) feeding resistive load, then

View solution

Q. A semi converter operates in two quadrants.

View solution

Q. Assertion (A): An ideal rectifier should have unity harmonic factor

Reason (R): An ideal rectifier should have unity displacement factor.

View solution

Q. A single phase half wave rectifier is feeding a resistive load. When α = 0, dc output voltage is 127 V. When α = 30°, the dc output voltage will be about

View solution

Q. A two winding transformer is feeding a single phase half wave rectifier circuit. The load is purely resistive. The rms value of transformer secondary current is Is and rms value of load current in Irms. Then

View solution

Q. The terminals of a power BJT are called

View solution

Q. In single phase half wave regulator, the average current over one full cycle

View solution

Q. The dynamic equalising circuit consists of a series combination of capacitor C and resistor RC across each thyristor. This resistance RC (along with parallel connected diode)

View solution

Q. A single phase semiconverter is feeding a highly inductive load and has freewheeling diode across the load. The waveshapes of output voltage and output current

View solution

Q. An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be

View solution

Q. The characteristics of a non-linear resistance is i = kv⁴. If i becomes 100 times, v becomes

View solution

Q. In a step down chopper using pulse width modulation, Ton = 3 x 10¯³ and Toff = 1 x 10¯³ s. The chopping frequency is

View solution

Q. Thyristors are suitable for dc circuit breakers but not for ac circuit breakers.

View solution