Question

The terminals of a power BJT are called

a.

emitter, base, collector

b.

emitter, base, drain

c.

source, base, drain

d.

source, base, collector

Answer: (a).emitter, base, collector

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The terminals of a power BJT are called

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In single phase half wave regulator, the average current over one full cycle

Q. The dynamic equalising circuit consists of a series combination of capacitor C and resistor RC across each thyristor. This resistance RC (along with parallel connected diode)

Q. A single phase semiconverter is feeding a highly inductive load and has freewheeling diode across the load. The waveshapes of output voltage and output current

Q. An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be

Q. The characteristics of a non-linear resistance is i = kv⁴. If i becomes 100 times, v becomes

Q. In a step down chopper using pulse width modulation, Ton = 3 x 10¯³ and Toff = 1 x 10¯³ s. The chopping frequency is

Q. Thyristors are suitable for dc circuit breakers but not for ac circuit breakers.

Q. Assertion (A): Inverters and choppers use fast switching thyristors

Reason (R): Fast switching SCR has low turn off time.

Q. The number of leads in an SCR are :

Q. A thyristor has a turn on time of 6 μs. If the anode circuit is inductive, the turn on time will be

Q. The total number of leads in reverse conducting thyristor is

Q. Assertion (A): A TRIAC is a bidirectional SCR.

Reason (R): A TRIAC is a four layers 3 terminal device and can conduct in both directions.

Q. The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by

Q. A chopper

Q. Assertion (A): If the duty cycle of chopper is low the current would not become discontinuous

Reason (R): If the time constant L/R of the load in chopper is low the current may become discontinuous.

Q. In a single phase full wave regulator, the firing angles in the positive and negative half cycles are generally

Q. An electric heater is controlled by thyristors through on-off control. If α = 0.4, the heating is

Q. A single phase half wave controlled rectifier circuit has a free wheeling diode. The load is a combination of R and L. The firing angle is α. The period of conduction of SCR and free wheeling diode respectively are

Q. Assertion (A): A transistor requires a continuous base signal for conduction but a thyristor requires a gate pulse.

Reason (R): Transistor find widespread application in power electronic circuits.

Q. In a thyristor the gate current is increased, then

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!