Q. A thyristor has a turn on time of 6 μs. If the anode circuit is inductive, the turn on time will be

View solution

Q. The total number of leads in reverse conducting thyristor is

View solution

Q. Assertion (A): A TRIAC is a bidirectional SCR.

Reason (R): A TRIAC is a four layers 3 terminal device and can conduct in both directions.

View solution

Q. The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by

View solution

Q. A chopper

View solution

Q. Assertion (A): If the duty cycle of chopper is low the current would not become discontinuous

Reason (R): If the time constant L/R of the load in chopper is low the current may become discontinuous.

View solution

Q. In a single phase full wave regulator, the firing angles in the positive and negative half cycles are generally

View solution

Q. An electric heater is controlled by thyristors through on-off control. If α = 0.4, the heating is

View solution

Q. A single phase half wave controlled rectifier circuit has a free wheeling diode. The load is a combination of R and L. The firing angle is α. The period of conduction of SCR and free wheeling diode respectively are

View solution

Q. Assertion (A): A transistor requires a continuous base signal for conduction but a thyristor requires a gate pulse.

Reason (R): Transistor find widespread application in power electronic circuits.

View solution

Q. In a thyristor the gate current is increased, then

View solution

Q. Thyristors are not suitable for logic circuits.

View solution

Q. In a circuit using a full wave converter (M - 2 connection) the PIV of each thyristor is 400 V. For the same output voltage and fully controlled bridge converter, PIV will be

View solution

Q. A dc separately excited motor has constant field current. The armature is fed from a single phase supply through a full converter. When α = 0, speed is 500 rpm. If α = 45°, the speed is likely to be

View solution

Q. In a multiphase chopper, all choppers operate together.

View solution

Q. The terminals of a power MOSFET are called

View solution

Q. Assertion (A): The surge current which an SCR can withstand is much higher than rms on state current.

Reason (R): The duration of surge current is very small.

View solution

Q. Current derating may be necessary when thyristors are operating in

View solution

Q. If duty cycle is a and the load is α resistance R, the rms value of output voltage is

View solution

Q. For a BJT, α = 0.98, then β =

View solution