Q. The terminals of a power MOSFET are called

View solution

Q. Assertion (A): The surge current which an SCR can withstand is much higher than rms on state current.

Reason (R): The duration of surge current is very small.

View solution

Q. Current derating may be necessary when thyristors are operating in

View solution

Q. If duty cycle is a and the load is α resistance R, the rms value of output voltage is

View solution

Q. For a BJT, α = 0.98, then β =

View solution

Q. Assertion (A): Power transistor has lower switching time than SCR

Reason (R): Power transistor has greater switching time than SCR

View solution

Q. A 3 kV circuit uses SCR of 800 V rating. If derating is 25%, the number of SCRs in series is

View solution

Q. The number of doped regions in a SCR is

View solution

Q. All inverters use forced commutation.

View solution

Q. In 180° mode of operation of a 3 phase bridge inverter, two thyristors conduct at one time.

View solution

Q. In a single phase full wave ac regulator the rms value of load current is 20 A load is purely resistive. Then

View solution

Q. A reactor is used in a dual converter operating in non-circulating current mode.

View solution

Q. In a 3 phase full wave regulator feeding resistance load connected in star, the possible range of firing angle α is

View solution

Q. Assertion (A): A dual converter may be circulating current type or non circulating current type.

Reason (R): In circulating current dual converter only one converter can be operated at one time.

View solution

Q. Current chopping leads to

View solution

Q. A 3 phase bridge inverter is fed by 400 V battery. The load is star connected and has a resistance of 10 Ω per phase. The peak value of load current is

View solution

Q. In an SCR, the anode current is controlled by

View solution

Q. The rated current of a thyristor is 40 A. The holding current will be about :

View solution

Q. A cycloconverter is

View solution

Q. The number of leads in a power semiconductor diode are

View solution