Q. Assertion (A): A dual converter may be circulating current type or non circulating current type.

Reason (R): In circulating current dual converter only one converter can be operated at one time.

View solution

Q. Current chopping leads to

View solution

Q. A 3 phase bridge inverter is fed by 400 V battery. The load is star connected and has a resistance of 10 Ω per phase. The peak value of load current is

View solution

Q. In an SCR, the anode current is controlled by

View solution

Q. The rated current of a thyristor is 40 A. The holding current will be about :

View solution

Q. A cycloconverter is

View solution

Q. The number of leads in a power semiconductor diode are

View solution

Q. If ton and toff are the turn on and turn off times of a thyristor, then

View solution

Q. Assertion (A): The gate current of an SCR is always in the form of pulses.

Reason (R): The gate losses, in pulse triggering, are low.

View solution

Q. The average load current supplied by a thyristor depends on

View solution

Q. In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be

View solution

Q. A thyristor is reverse biased. A positive gate pulse is applied. The thyristor

View solution

Q. A single phase series converter is used for

View solution

Q. Which of these commutation methods uses an auxiliary SCR?

View solution

Q. In integral cycle control the period of on-off control should be more than mechanical time constant of load.

View solution

Q. A single phase half wave converter is feeding a resistive load. Just before triggering, the voltage across thyristor is

View solution

Q. UJT can be used for

View solution

Q. In a series inverter supplying a load resistance R, the commutating elements L and C should be such that

View solution

Q. In a full wave converter (M - 2 connection) feeding an RLE load, the peak thyristor current is 15 A. For fully controlled bridge circuit and same load current, the peak thyristor current will be

View solution

Q. Induction heating systems require low frequency inverters.

View solution