Question
Reason (R): Transistor find widespread application in power electronic circuits.
a.
Both A and R are correct and R is correct explanation of A
b.
Both A and R correct but R is not correct explanation of A
c.
A is correct but R is wrong
d.
A is wrong but R is correct
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Assertion (A): A transistor requires a continuous base signal for conduction but a thyristor requires a gate pulse. Reason (R): Transistor find widespread application in power...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a thyristor the gate current is increased, then
View solution
Q. Thyristors are not suitable for logic circuits.
View solution
Q. In a circuit using a full wave converter (M - 2 connection) the PIV of each thyristor is 400 V. For the same output voltage and fully controlled bridge converter, PIV will be
View solution
Q. A dc separately excited motor has constant field current. The armature is fed from a single phase supply through a full converter. When α = 0, speed is 500 rpm. If α = 45°, the speed is likely to be
View solution
Q. In a multiphase chopper, all choppers operate together.
View solution
Q. The terminals of a power MOSFET are called
View solution
Q. Assertion (A): The surge current which an SCR can withstand is much higher than rms on state current.
Reason (R): The duration of surge current is very small.
View solution
Q. Current derating may be necessary when thyristors are operating in
View solution
Q. If duty cycle is a and the load is α resistance R, the rms value of output voltage is
View solution
Q. For a BJT, α = 0.98, then β =
View solution
Q. Assertion (A): Power transistor has lower switching time than SCR
Reason (R): Power transistor has greater switching time than SCR
View solution
Q. A 3 kV circuit uses SCR of 800 V rating. If derating is 25%, the number of SCRs in series is
View solution
Q. The number of doped regions in a SCR is
View solution
Q. All inverters use forced commutation.
View solution
Q. In 180° mode of operation of a 3 phase bridge inverter, two thyristors conduct at one time.
View solution
Q. In a single phase full wave ac regulator the rms value of load current is 20 A load is purely resistive. Then
View solution
Q. A reactor is used in a dual converter operating in non-circulating current mode.
View solution
Q. In a 3 phase full wave regulator feeding resistance load connected in star, the possible range of firing angle α is
View solution
Q. Assertion (A): A dual converter may be circulating current type or non circulating current type.
Reason (R): In circulating current dual converter only one converter can be operated at one time.
View solution
Q. Current chopping leads to
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
