Question
a.
α
b.
2 α
c.
4 α
d.
0.5 α
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A single phase semiconverter is feeding a highly inductive load. The circuit has a freewheeling diode across the load and firing angle is α. During one cycle of input voltage, the...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. During forward blocking state of SCR, the voltage and current respectively are
View solution
Q. In a 3 phase full converter the average load current is 150 A. The average thyristor current is
View solution
Q. The two modes of operation of three phase bridge inverters are known as
View solution
Q. To protect an SCR against high di/dt we connect
View solution
Q. In a parallel inverter
View solution
Q. A silicon controlled switch has :
View solution
Q. A dc chopper V = 500 V feeds an electric fraction dc series motor. The chopping frequency is 400 Hz. The series inductance required to limit the maximum current swing to 10 A is
View solution
Q. A single phase fully controlled bridge rectifier is fed by a source having inductance. The output voltage during overlap period is
View solution
Q. A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = Vm sin ωt. The thyristor will conduct
View solution
Q. In a 3 phase semiconverter, the firing frequency is
View solution
Q. Present day HVDC converters are all
View solution
Q. A single phase full converter gives maximum and minimum output voltage at firing angles of
View solution
Q. A thyristor has its gate current zero. To start conduction the forward voltage must exceed
View solution
Q. Assertion (A): Snubber circuit has an RC series circuit in parallel with SCR
Reason (R): Voltage across a capacitor can not change instantaneously.
View solution
Q. In dielectric heating, the thyristor circuits consist of
View solution
Q. On load tap changer using thyristors can have a maximum of two taps.
View solution
Q. Assertion (A): A cycloconverter may be line commutated or forced commutated
Reason (R): A step up cycloconverter requires forced commutation.
View solution
Q. When thyristors are connected in series and parallel, it may be necessary to have :
View solution
Q. A single phase half wave regulator uses
View solution
Q. A Shockley diode can be used
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
