Q. The two modes of operation of three phase bridge inverters are known as

View solution

Q. To protect an SCR against high di/dt we connect

View solution

Q. In a parallel inverter

View solution

Q. A silicon controlled switch has :

View solution

Q. A dc chopper V = 500 V feeds an electric fraction dc series motor. The chopping frequency is 400 Hz. The series inductance required to limit the maximum current swing to 10 A is

View solution

Q. A single phase fully controlled bridge rectifier is fed by a source having inductance. The output voltage during overlap period is

View solution

Q. A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = Vm sin ωt. The thyristor will conduct

View solution

Q. In a 3 phase semiconverter, the firing frequency is

View solution

Q. Present day HVDC converters are all

View solution

Q. A single phase full converter gives maximum and minimum output voltage at firing angles of

View solution

Q. A thyristor has its gate current zero. To start conduction the forward voltage must exceed

View solution

Q. Assertion (A): Snubber circuit has an RC series circuit in parallel with SCR

Reason (R): Voltage across a capacitor can not change instantaneously.

View solution

Q. In dielectric heating, the thyristor circuits consist of

View solution

Q. On load tap changer using thyristors can have a maximum of two taps.

View solution

Q. Assertion (A): A cycloconverter may be line commutated or forced commutated

Reason (R): A step up cycloconverter requires forced commutation.

View solution

Q. When thyristors are connected in series and parallel, it may be necessary to have :

View solution

Q. A single phase half wave regulator uses

View solution

Q. A Shockley diode can be used

View solution

Q. An SCR has a turn on time of 4 μs. The gate pulse should have a duration of about

View solution

Q. In a multiphase chopper, the different choppers operate in

View solution