Q. All other parameters remaining the same, a 3 phase bridge inverter with 180° mode of operation

View solution

Q. As compared to BJT, MOSFET has

View solution

Q. A current source inverter has simple commutation circuit.

View solution

Q. In load commutated chopper, the commutating element

View solution

Q. In a half bridge inverter each thyristor is gated at a frequency f. The output frequency is

View solution

Q. Assertion (A): A transistor has lower voltage drop during conduction as compared to thyristor

Reason (R): Transistors are manufactured in very high voltage and current ratings.

View solution

Q. Assertion (A): Typical value of thermal resistance from source to sink of an SCR is about 0.3° C/W

Reason (R): Heat sinks of thyristors are generally made of aluminium.

View solution

Q. In a thyristors are i = kvᵃ. The value of a is

View solution

Q. In an ordinary thyristor

View solution

Q. Thyristors connected in series need :

View solution

Q. If 4 quadrant operation is required we need

View solution

Q. Which of these commutation methods uses an external pulse for commutation?

View solution

Q. In a single phase full wave regulator feeding an R-L load, the power factor angle of load is θ. The range of control of firing angle α is

View solution

Q. A separately excited dc motor is run from a dc source through a chopper. At 600 rpm and rated torque, the duty cycle of chopper is 0.8. At 600 rpm and half the rated torque, the duty cycle is likely to be

View solution

Q. A relaxation oscillator uses

View solution

Q. In a stud mounted SCR, the stud is

View solution

Q. In pulse width modulation of chopper

View solution

Q. In a full bridge inverter, the waveshape of load current depends on

View solution

Q. The characteristics of which device has peak point and valley point

View solution

Q. In brushless excitation system of modern alternators, the main exciter is

View solution