Question
Reason (R): A GTO can be turned off by negative gate pulse.
a.
Both A and R are correct and R is correct explanation of A
b.
Both A and R correct but R is not correct explanation of A
c.
A is correct but R is wrong
d.
A is wrong but R is correct
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Assertion (A): A GTO can be turned on and turned off by gate pulses Reason (R): A GTO can be turned off by negative gate pulse.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a full bridge single phase inverter feeding RLC load
View solution
Q. It is possible to use a freewheeling diode in
View solution
Q. Assertion (A): When the anode current of an SCR starts increasing during turn on process, the anode cathode voltage drop starts decreasing.
Reason (R): During turn on the reverse biased junction in SCR breaksdown.
View solution
Q. An SCR is triggered at 80° in the positive half cycle, only. The rms anode current is 25 A. If the firing angle is changed to 160°, the rms current is likely to be
View solution
Q. The output wave of a cycloconverter consists of a number of segments derived from the input wave.
View solution
Q. A class A chopper has an input voltage of 200 V. Ton = 1.5 ms and Toff = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are
View solution
Q. A TRIAC can be turned on :
View solution
Q. In a half bridge inverter the gate pulses of the two thyristors have a phase displacement of
View solution
Q. A fully controlled bridge converter can operate in quadrants
View solution
Q. A class E chopper
View solution
Q. A cycloconverter uses
View solution
Q. Assertion (A): A fully controlled bridge converter can operate in first and fourth quadrant.
Reason (R): A semi converter is cheaper than a full converter.
View solution
Q. A fully controlled bridge converter is feeding an RLE load. The load current is I0. The input voltage is Vm sin ωt. The KVL equation to find firing angle a is
View solution
Q. A single phase cycloconverter with centre tapped input transformer requires
View solution
Q. In a 3 phase bridge inverter with 120° mode of operation the. number of thyristors conducting at one time are
View solution
Q. The number of thyristors in a single phase fully controlled bridge rectifier is
View solution
Q. In a bridge inverter
View solution
Q. An ideal rectifier should have
View solution
Q. When thyristors are connected in parallel, the current distribution may become non-uniform due to
View solution
Q. As compared to a p-n junction diode
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
