Q. It is possible to use a freewheeling diode in

View solution

Q. Assertion (A): When the anode current of an SCR starts increasing during turn on process, the anode cathode voltage drop starts decreasing.

Reason (R): During turn on the reverse biased junction in SCR breaksdown.

View solution

Q. An SCR is triggered at 80° in the positive half cycle, only. The rms anode current is 25 A. If the firing angle is changed to 160°, the rms current is likely to be

View solution

Q. The output wave of a cycloconverter consists of a number of segments derived from the input wave.

View solution

Q. A class A chopper has an input voltage of 200 V. Ton = 1.5 ms and Toff = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are

View solution

Q. A TRIAC can be turned on :

View solution

Q. In a half bridge inverter the gate pulses of the two thyristors have a phase displacement of

View solution

Q. A fully controlled bridge converter can operate in quadrants

View solution

Q. A class E chopper

View solution

Q. A cycloconverter uses

View solution

Q. Assertion (A): A fully controlled bridge converter can operate in first and fourth quadrant.

Reason (R): A semi converter is cheaper than a full converter.

View solution

Q. A fully controlled bridge converter is feeding an RLE load. The load current is I0. The input voltage is Vm sin ωt. The KVL equation to find firing angle a is

View solution

Q. A single phase cycloconverter with centre tapped input transformer requires

View solution

Q. In a 3 phase bridge inverter with 120° mode of operation the. number of thyristors conducting at one time are

View solution

Q. The number of thyristors in a single phase fully controlled bridge rectifier is

View solution

Q. In a bridge inverter

View solution

Q. An ideal rectifier should have

View solution

Q. When thyristors are connected in parallel, the current distribution may become non-uniform due to

View solution

Q. As compared to a p-n junction diode

View solution

Q. From which instant is the turn off time of a thyristor defined

View solution