Question

State transition table and state transition diagram form part of design steps for

a.

combinational circuits

b.

sequential circuits

c.

delay circuits

d.

all of the above

Answer: (b).sequential circuits

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. State transition table and state transition diagram form part of design steps for

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Which binary subtraction is incorrect?

Q. Consider the following statements:

1. Race around condition can occur in JK flip flop when both inputs are 1
2. A flip flop is used to store one bit of information
3. A transparent latch is a D type flip flop
4. Master slave flip flop is used to store two bits of information

Which of the above are correct?

Q. NAND and NOR gates are universal gates.

Q. The control logic for a binary multiplier is specified by a states diagram. The state diagram has four states and two inputs. To implement it by the sequence register and decoder method.

Q. A hexadecimal odometer displays F52F. The next reading will be

Q. Which of them has 10 inputs and 4 outputs?

Q. The binary number 0.10110111101 is equal to hexadecimal number

Q. In order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instructions are needed?

Q. Digital technologies being used now-a-days are

Q. A seven bit code (even parity) 1111101 may have error. The correct code is

Q. A/D parallel converter is also called flash converter.

Q. Square root of 4 is

Q. Schmitt trigger can be used as a

Q. Most of the digital computers do not have floating-point hardware because

Q. The number of FF required for a divide by 12 circuit is

Q. In sign magnitude numbers,

Q. Consider the following statements: A multiplier

1. selects one of the several inputs and steers it to the output
2. routes the data from a single input to many outputs
3. converts parallel data into serial data
4. is a combinational circuit

Of the above statements which are correct?

Q. In the full adder, denoting Sum by S and carry by C

Q. Each term in POS form is called max terms.

Q. When signed numbers are used in binary arithmetic, which of the following has unique representation for zero?

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!