Q. In 8085 microprocessor, what is the length of IR (instruction register)?

View solution

Q. A sequence detector is required to give a logical output of 1 whenever the sequence 1011 is detected in the incoming pulse stream. Minimum number of flip-flops needed to built the sequence detector is

View solution

Q. In a shift register the data is loaded in one operation but shifted out one bit at a time, The shift register is

View solution

Q. In CCD

View solution

Q. Dual slope ADC uses an op amp comparator.

View solution

Q. The output of the 74 series of TTL gates is taken from a BST in

View solution

Q. In the above case the hexadecimal notation for the last memory location is

View solution

Q. What is the length of SP (Stack pointer) of 8085 μp?

View solution

Q. Shifting digits from left to right and vice versa is needed in

View solution

Q. Current requirement of a piezo buffer is about

View solution

Q. Consider the following instruction of 8085 μp :

1. MOV M, A
2. AODC
3. MVI A, FF
4. CMP M

Which of these cause change in the status of flag(s)?

View solution

Q. A microprocessor with a 16-bit address bus is used in a linear memory selection configuration (i.e., Address bus lines are directly used as chip selects of memory chips) with 4 memory chips. The maximum addressable memory space is

View solution

Q. The logic represented by the abbreviation ECL is

View solution

Q. A (A + B) =

View solution

Q. One of the function of the SiO₂ layer in an IC is to

View solution

Q. Monostable multivibrator is called one-shot or single-shot circuit because it

View solution

Q. 10's complement of 16₁₀ is

View solution

Q. The hexadecimal number 64 AC is equivalent to decimal number

View solution

Q. A binary with a digits, all of which are unity has the value

View solution

Q. In a NAND SR latch S = R = 1. Then

View solution