Question

The total number of channels allotted for cellular telephone is

a.

666

b.

333

c.

221

d.

111

Answer: (a).666

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The total number of channels allotted for cellular telephone is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. It is found that in a telephone system 60 subscribers initiate calls during a 30 minute interval and the total duration of all the calls is 100 minutes. The load is

Q. E and H fields are perpendicular to each other.

Q. Consider the following:

1. A TV receiver antenna should pick up the TV signal and develop maximum voltage from the available strength of signal
2. It should reject unwanted signals
3. It should not suffer from co-channel interference
4. It should have a very narrowband

The correct statements are

Q. If transmission bandwidth is doubled in FM, SNR is

Q. Directivity means

Q. If the oscillator output is modulated by audio frequencies upto 10 kHz, the frequency range occupied by the side bands will be

Q. The power to the portable unit of a cordless telephone is provided by

Q. In a AM wave the carrier and one of the side bands is suppressed. If m = 0.5, the percentage saving in power is

Q. Computer communication networks have

Q. Assertion (A): A balun is an RF impedance matching transformer.

Reason (R): Sometimes a booster amplifier is used with a TV set.

Q. In a TV, studio the function of vision switcher is to

Q. Y signal has maximum percentage of

Q. To ensure good transient response in audio systems the natural frequencies should be

Q. Consider the following features of monochrome TV

1. Number of lines per picture - 625
2. Interlace ratio - 2 : 1
3. Aspect ratio - 4 : 3
4. Channel bandwidth - 8 MHz

As regards CCIR system B, which of the above are correct?

Q. In the absence of noise, if C is channel capacity in bits/s, δf is channel bandwidth in Hz and N is number of coding levels. Then

Q. The open loop gain of an amplifier is 50 but is likely to change by 20%. If negative feedback with β = 0.1 is used, the change in gain will be about

Q. Audio amplifiers need

Q. For an ideal 3000 Hz channel, S/N ratio is

Q. Which of the following types of noise assumes greater importance at high frequencies?

Q. In transistor radio receivers the number of IF amplifier stages are

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!