Question
a.
1
b.
2
c.
4
d.
6
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In transistor radio receivers the number of IF amplifier stages are
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. To relay outdoor remotely located live programs, TV transmitter use
View solution
Q. If each short element of signal occupies 20 ms, the speed is
View solution
Q. The Hilbert transform of cos ω₁t + sin ω₂t is
View solution
Q. In ionosphere incidence angle is 60°. The maximum usable frequency fm is equal to
View solution
Q. The generally used value of EHV supply in TV receivers is
View solution
Q. The number of channels available in MF band (300 kHz - 3 MHz) for AM modulating signal of 20 kHz is
View solution
Q. The function of blend control in stereo system is
View solution
Q. The output resistance of a microphone is 20 ohms. It is to feed a line of impedance 320 ohms. To ensure maximum power transfer, the turn ratio of transformer is
View solution
Q. In a reactance FET, gm = 9 x 10‾³ Siemens, gate to source resistance is one-ninth of reactance of gate to drain capacitor and frequency is 4 MHz. The capacitive-reactance is
View solution
Q. Audio cassettes used in household tape recorders have a width of
View solution
Q. The receiver of a pulsed RADAR can detect signal power in the order of
View solution
Q. In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
View solution
Q. The number of channels in a stereophonic system is
View solution
Q. When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
View solution
Q. A signal x(t) = 100 cos (24π x 10³t) is ideally sampled with a sampling period of 50 μ sec and then passed through an ideal low pass filter with cut off frequency of 15 kHz Which of the following frequencies are present at the filter output?
View solution
Q. A sinusoidal voltage of 2 kV peak value is amplitude modulated to give 20% modulation. The peak value of each side band term is
View solution
Q. Consider the following reasons for using antenna coupler
1. To prevent illegal radiation of spurious frequencies
2. To tune out reactive components of antenna impedance
3. To have correct value of load impedance for transmitter
Which of the above are correct?
View solution
Q. Which of the following microphones works on the principle of Faraday's law?
View solution
Q. In a CE amplifier connection, the emitter is at ground potential for
View solution
Q. In an AM wave with m = 1, the carrier is suppressed. The resulting power saving will be
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!