Question
a.
low pass filter
b.
high pass filter
c.
band pass filter
d.
band stop filter
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A tweeter should be fed from the input through a
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The modulation index is, if fm = 500 Hz, Δf = 2.25 kHz
View solution
Q. Which of the following is true in a tape recorder?
View solution
Q. In a high speed modem the data rate handled is about
View solution
Q. Trinitron is a monochrome picture tube.
View solution
Q. The first pulse in a TV remote control is
View solution
Q. If the ratio of ac to dc load impedance of a diode detector is low, the result will be
View solution
Q. If D is mouth diameter of a paraboloid reflector, its directivity is proportional to
View solution
Q. A noiseless 3 kHz channel can't transmit binary bit at the rate
View solution
Q. In an AM wave the carrier and one of the side bands is suppressed. If m = 1, the percentage saving in power is
View solution
Q. Assertion (A): An electronic tuner uses varactor diode
Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.
View solution
Q. A superheterodyne receiver is to operate in the frequency range 550 kHz - 1650 kHz, with the intermediate frequency of 450 kHz. Let R = Cmin/Cmax denote the required capacitance ratio of the local oscillator and I denote the image frequency (in kHz) of the incoming signal. If the receiver is tuned to 700 kHz, then
View solution
Q. In a tape recorder the output from RF oscillator is given to
View solution
Q. A + 1.9 lens has a focal length of 25 mm. The diameter of lens is about
View solution
Q. Which of the following terms are applicable to troposcatter propagation?
View solution
Q. If the amplitude of the voltage is kept constant, but its frequency is raised to 6 kHz, the new deviation will be for the modulation index is, if fm = 500 Hz, Δf = 2.25
View solution
Q. In TV scanning sequence of lines is
View solution
Q. In equally tampered scale, frequency of each tone equals the frequency of lower adjacent tone multiplied by
View solution
Q. A carrier is modulated by two modulating waves A and B having modulation indices of 0.6 and 0.8 respectively. The overall modulation index is
View solution
Q. A communication channel disturbed by additive white, Gaussian noise has a bandwidth of 4 kHz and SNR of 15. The highest transmission rate that this channel can support (in k bits/sec) is
View solution
Q. Which of the following microphones is used as a standard for calibration?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!