Question

A high pulse repetition frequency in a radar

a.

increases the maximum range

b.

decreases the maximum range

c.

has no effect on the maximum range

d.

either (a) or (b) depending on other factors

Answer: (c).has no effect on the maximum range

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. A high pulse repetition frequency in a radar

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In PCM, the biggest disadvantage as compared to AM is

Q. Which of the following microphones is the cheapest?

Q. If a line is terminated in characteristic impedance Z₀, the input impedance measured at the input will be

Q. In a TV, the output from RF tuner is about

Q. 24 telephone channels, each band limited to 3.4 kHz, are to be time division multiplexed by using PCM, calculate the bandwidth of PCM system for 128 quantization levels and an 8 KHz sampling frequency

Q. A signal is sampled at 8 kHz and is quantized using 8 bit uniform quantizer. Assuming SNRq for a sinusoidal signal, the correct statement for PCM signal with a bit rate of R is

Q. Generally a VCR has

Q. An antenna has a resistance of 50 Ω and an equivalent noise resistance of 30 Ω The noise figure in decibels is

Q. An MTI radar operating at 5 GHz has a PRF of 800 pps. The lowest blind speed is

Q. For maximum output the width of air gap of audio head should be

Q. The simplest mixer circuit for public address system uses

Q. PAM stands for

Q. A Discone antenna is

Q. In a two tone AM system the two modulating frequencies are 2000 π and 4000 π rad/sec. If carrier frequency is 2π x 10⁶ rad/sec the frequencies of upper sidebands are

Q. For a system to be designated as hi-fi, the signal to noise ratio should be at least

Q. Dolby system of noise reduction divides the total audio spectrum into

Q. In a system an input resistance of 20 kΩ causes a noise voltage of 15μV. If two such input resistances each of 20 kΩ are used in parallel, the total noise voltage will be about

Q. A sinusoidal signal with peak to peak amplitude of 1.536 volt is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is

Q. An FM wave is made to pass through a frequency tripler. If original modulation index is mf, the output of tripler has a modulation index equal to

Q. A balun provides an impedance transformation of

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!