Q. For maximum output the width of air gap of audio head should be

View solution

Q. The simplest mixer circuit for public address system uses

View solution

Q. PAM stands for

View solution

Q. A Discone antenna is

View solution

Q. In a two tone AM system the two modulating frequencies are 2000 π and 4000 π rad/sec. If carrier frequency is 2π x 10⁶ rad/sec the frequencies of upper sidebands are

View solution

Q. For a system to be designated as hi-fi, the signal to noise ratio should be at least

View solution

Q. Dolby system of noise reduction divides the total audio spectrum into

View solution

Q. In a system an input resistance of 20 kΩ causes a noise voltage of 15μV. If two such input resistances each of 20 kΩ are used in parallel, the total noise voltage will be about

View solution

Q. A sinusoidal signal with peak to peak amplitude of 1.536 volt is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is

View solution

Q. An FM wave is made to pass through a frequency tripler. If original modulation index is mf, the output of tripler has a modulation index equal to

View solution

Q. A balun provides an impedance transformation of

View solution

Q. If γ = (S0/N0)/(Si/Nm) where S0 and S1 are signal power output and signal power input and N0 and Nm are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are

View solution

Q. Which of the following amplifiers is used for impedance matching?

View solution

Q. Which of the following amplifiers has highest output impedance?

View solution

Q. In a superheterodyne receiver, having no RF amplifier, the IF is 455 kHz. The image frequency at 1000 kHz is

View solution

Q. Audio tapes have two tracks each 2.5 mm wide.

View solution

Q. Which of the following amplifiers has a voltage gain of less than 1?

View solution

Q. Some possible disadvantages of high level modulation in TV transmitters are

1. Video monitor has to supply high video voltages upto several hundred volts into highly capacitive loads drawing high current at video frequencies
2. The grid modulated stage presents a varying load to its driver
3. The linearity and high video driving power present design problems

Out of above which are true?

View solution

Q. Beam width of an antenna is expressed in

View solution

Q. In broadcast television, the number of lines per frame is chosen to be odd number to

View solution