Question

In broadcast television, the number of lines per frame is chosen to be odd number to

a.

reduce the required bandwidth

b.

improve resolution

c.

reduce peak power requirement

d.

make interlacing easier

Answer: (d).make interlacing easier

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In broadcast television, the number of lines per frame is chosen to be odd number to

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In a picture tube, the video signal is applied to

Q. If frames are repeated at 60 Hz and each frame has 525 lines, the time for scanning one horizontal line (for progressive scanning and no interlacing) is about

Q. The name modem is a contraction of terms modulator demodulator.

Q. The use of SSB

Q. Video signals are transmitted through

Q. A TV receiver has 20 kV EHT supply and total beam current (for 3 electron guns) of 1500 μA. The power handled by IHVT is

Q. Full duplex operation

Q. In a tape recorder the erase head is

Q. Consider the following statements as regards advantages of CCD sensors as camera pick up tube

1. High sensitivity
2. Good spectral response
3. Image lag absent

Out of the above which are correct

Q. Some desirable features of a computer communication network are

1. It should accept an intended transmission without excessive delay
2. The data arriving at a receiving point should be processed rapidly
3. When a transmission calls for a response, the delay of response should be minimum.

Which of the above are true?

Q. Television transmission is by

Q. In the television system in India, the aspect ratio is

Q. In high power radars, which of the following are used for switching?

Q. A remote control for TV uses

Q. In the FM wave described by equation v = 15 sin (4 x 10⁸ t + 3 sin 1100 t), the carrier frequency and signal frequency respectively are

Q. In the television system in India, the odd and even fields are scanned

Q. Consider the following:

1. A signal f(t) and its Hilbert transform fh(t) have the same energy density spectrum
2. A signal f(t) and its Hilbert transform, fh(t) have the same auto correlation function
3. A signal f(t) and its Hilbert transform are mutually orthogonal

Which of the above are true?

Q. Vidicon and plumbicon operate on the principle of

Q. A TV receiver has a width of 60 cm. The aspect ratio is 4/3. The required EHT supply is about

Q. The typical squelch circuit

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!