Question
a.
shunt capacitance
b.
series capacitance
c.
shunt inductance
d.
series inductance
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. For attenuation of low frequencies we should use
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Assertion (A): A colour TV uses a SAW filter to give stable band pass response and high gain.
Reason (R): Devices using SAW principle are used in many systems.
View solution
Q. In an FM signal, the modulating frequency is 2 kHz and maximum deviation is 10 kHz. The bandwidth requirement is
View solution
Q. The effective length of antenna is different from actual length due to
View solution
Q. In a TV receiver there is no raster, no picture and no sound. The most likely defective stage is
View solution
Q. Noise can be measured by
View solution
Q. A 100 + j 100 Ω load is to be matched to a line with Z0 = 300 Ω to give SWR = 1. The reactance of stub is
View solution
Q. In VHS format each video head is tilted from azimuth by
View solution
Q. The number of possible colours with a 4 line digital input monitor are
View solution
Q. Convolution of x(t + 5) with impulse function δ(t - 7) is equal to
View solution
Q. Which of the following is a better recording medium?
View solution
Q. An angle modulated signal is given by s(t) = cos 2π (2 x 10⁶t + 30 sin 150t + 40 cos 150t). The maximum frequency and phase deviations of s(t) are
View solution
Q. Microwave link repeaters are typically 50 km apart in TV transmission due to
View solution
Q. Assertion (A): The colour signal consists of only luminance signal
Reason (R): In India PAL colour signal system is used.
View solution
Q. To separate channels in FDM receiver we have to use
View solution
Q. A device with input x(t) and y(t) is characterized by y(t) = x²(t). An FM signal with frequency deviation of 90 kHz and modulating signal bandwidth of 5 kHz is applied to this device. The bandwidth of the output signal is
View solution
Q. Assertion (A): Bandwidth of a TV signal is 5 MHz.
Reason (R): TV systems use vestigial side band transmission.
View solution
Q. In a satellite system circular polarization is to be obtained. The antenna used is
View solution
Q. A horizontal output stage is cutoff for retrace and 40% of trace. If time for each horizontal line is 64 μs and retrace time is 12 μs, the transistor is conducting for about
View solution
Q. A TV remote control works on the principle of
View solution
Q. As the magnitude of reverse bias is increased, the capacitance of varactor diode
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!