Question
a.
The system is basically phase, not frequency, modulation
b.
AFC is not needed, as a crystal oscillator is used
c.
Equalization is unnecessary
d.
Frequency multiplication must be used
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Which of the following is a false statement about Armstrong modulation system?
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Which one is digital modulation technique?
View solution
Q. Since noise phase modulated FM wave, as the noise sideband frequency approaches the carrier frequency, the noise amplitude
View solution
Q. Consider the following statements as regards DPSK and DEPSK
1. DPSK demodulator requires a device which operates at carrier frequency and provides a delay of bit time Tb
2. In DPSK, synchronous demodulation recovers the signal b(t) and the decoding of b(t) to generate d(t) is done at base band
3. In both DPSK and DEPSK errors always occur in pairs
Which of the above statements are correct?
View solution
Q. An audio frequency of 5 kHz is translated to a radio frequency carrier of frequency 1 MHz and transmitted it to space through an antenna. The required height of antenna is
View solution
Q. Pre-emphasis circuit is used
View solution
Q. In which frequency range is the noise figure in a transistor minimum
View solution
Q. In commercial FM Broadcasting, A radio station transmitting the signal at 98.3 MHz, it is
View solution
Q. Which of following digital modulation technique?
View solution
Q. A discrete zero memory information source has 40 symbols and each symbol is equally likely. The minimum number of bits required to code the source with uniform length code and entropy of the source are
View solution
Q. The standard intermediate frequency for FM ratio is
View solution
Q. In an end fire array, the radiation pattern
View solution
Q. Armstrong FM transmitter uses
View solution
Q. Which of the following microphones has highest output impedance?
View solution
Q. Consider the following statements about PCM
1. PCM is not noise resistant
2. PCM requires complex encoding and quantizing circuitry
3. PCM requires large bandwidth
Which of the above are correct?
View solution
Q. In a television transmitter, the output stage is most likely to be
View solution
Q. The number of bits of information required to indicate the correct selection of 3 independent consecutive events out of 75 equally probable events is
View solution
Q. The efficiency of a direct radiating cone type loudspeaker is about
View solution
Q. The message carrying efficiency is best in
View solution
Q. An SSB-AM signal cannot be demodulated by
View solution
Q. The pre-emphasis circuit is used
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!