Question
a.
S²
b.
S²/2
c.
S²/6
d.
S²/12
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. When a signal is quantized such that the step size S is small in comparison with the peak to peak range of the signal, the mean square quantization error is equal to
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Assertion (A): Many times a radar cannot detect 'grounding hopping' military aircraft.
Reason (R): Ground interference limits the range of radar.
View solution
Q. Entropies associated with an extremely unlikely message and that with an extremely likely message are respectively
View solution
Q. For TV broadcast, picture signal is modulated in
View solution
Q. Assertion (A): Stubs, directional couplers and baluns are very commonly used in communication systems
Reason (R): Characteristic impedance of a line is an important parameter.
View solution
Q. Audio frequency range lies between
View solution
Q. Assertion (A): SSB and ISB receivers have good S/N ratio
Reason (R): SSB and ISB receivers have good suppression of adjacent channels.
View solution
Q. De-emphasis circuit is used
View solution
Q. Which is most important subsystem for recovering and reconstructing signal in a TDM system?
View solution
Q. Which one of the following is an indirect way of generating FM?
View solution
Q. Companding is used in PCM to
View solution
Q. Assertion (A): In AM the amplitude of carrier is made proportional to the instantaneous amplitude of modulating wave
Reason (R): In AM, frequency of side band = frequency carrier ± frequency of modulating wave.
View solution
Q. Pressing a key on telephone set generates two frequencies. The basis for selection of these frequencies is
View solution
Q. Which of the following oscillator is not in FM?
View solution
Q. The number of spectral component of impulse wave is
View solution
Q. Assertion (A): If a carrier is modulated by three sine waves and m₁, m₂, m₃ are the modulation indices, the total modulation index mt is
mt = (m₁² + m₂² + m₃²)^0.5
Reason (R): An AM, higher the level of modulation, lower is the audio power required to produce modulation.
View solution
Q. If M (jω) = £[m(t)] where £ denotes Fourier transform, then £[m(t) cos ωct] =
View solution
Q. When a wave reaches the open circuited end of a line
View solution
Q. Some features of RF stage in good radio receivers is
1. It increases sensitivity by providing amplification to RF signal
2. It eliminates image frequency interference
3. It increases selectivity
4. It reduces noise level
Which of the above are true?
View solution
Q. During amplitude modulation, the phase angle of the modulating voltage changes by
View solution
Q. The image frequency of a superheterodyne receiver is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!