Question

In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about

a.

1.9 k bits/sec

b.

0.95 k bits/sec

c.

3.8 k bits/sec

d.

7.6 k bits/sec

Answer: (a).1.9 k bits/sec

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents...

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Super high frequency means more than 3000 MHz.

Q. Impedance inversion may be obtained with

Q. Which of the following is correct (FDM means Frequency Division Multiplexing and TDM means Time Division Multiplexing)?

Q. Consider the following applications/ advantages of radar beacons

1. navigation
2. target identification
3. accurate tracking of enemy targets
4. large increase in maximum range

Which of the above are correct?

Q. The signal plate of vidicon tube is coated with tin oxide.

Q. The maximum permissible distance between two samples of a 10 kHz signal

Q. In telephone systems, load is expressed in the unit of

Q. Which of the following can be used to convert PPM into PWM?

Q. For an antenna of height ht metres, the radio horizon is equal to

Q. If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.

Q. In the stabilized reactance modulator AFC system

Q. In AM, the modulation envelope has a peak value double the unmodulated carrier level, when the modulation is

Q. A bit synchronizer regenerates at the receiver a clock waveform which is

Q. Probability of error in DPSK is less than PSK

Q. Zero mean Gaussian noise of variance N is applied to a half wave rectifier. The mean squared value of the rectified output will be

Q. Two sine waves of amplitude A1 and A2 are multiplied. The amplitude of the spectral component is

Q. In radar display system PPI stands for

Q. When ωm is the modulation frequency in frequency modulation, the modulation index is proportional to

Q. A pre-emphasis circuit provides extra noise immunity by

Q. The function of a modulator is to

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!