Question
a.
input cavity
b.
output cavity
c.
intermediate cavity
d.
both (a) and (b)
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a three cavity klystron amplifier, the oscillations are excited in
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Assertion (A): A coaxial line is a non-radiating line.
Reason (R): In a coaxial line the electric and magnetic fields are confined to the region between the concentric conductors.
View solution
Q. Reflex klystron oscillator is essentially a low power device
View solution
Q. A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
View solution
Q. A matched generator (Zg = Z0) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are
View solution
Q. Which TM mode in rectangular waveguide has lowest cutoff frequency?
View solution
Q. The velocity factor of a transmission line depends on
View solution
Q. A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is
View solution
Q. In a klystron amplifier the input cavity is called
View solution
Q. In a circular waveguide the dominant mode is
View solution
Q. The reflection coefficient on a line is 0.2 ∠45°. The SWR is
View solution
Q. For a 50 Ω resistor for 3 GHz application, the stray capacitance should be less than
View solution
Q. In a travelling wave tube distributed interaction between an electron beam and a travelling wave takes place
View solution
Q. The fabrication of microstrip line is done by
View solution
Q. The condition of minimum distortion in a transmission line is
View solution
Q. A resistive microwave load with ZL = 150 Ω is connected to 50 Ω coaxial line. SWR is
View solution
Q. Which of the following devices uses a slow wave structure?
View solution
Q. In a turnstile antenna two-half wave resonant wire radiators are placed at 90° to each other in the same plane and are excited
View solution
Q. A waveguide section in a microwave circuit acts as
View solution
Q. In a klystron amplifier dc electron velocity is v₀ and dc electron charge density is ρ₀ the dc beam current is
View solution
Q. Which of the following parameters is negligible in transmission lines?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
