Q. A branched duplexer requires

View solution

Q. In a backward wave oscillator the wave

View solution

Q. A transmission line has Z0 = 300 Ω and ZL = (300 - j300) ohm. The transmission coefficient is

View solution

Q. In a reflex klystron oscillator, repeller electrode is at

View solution

Q. A quarter wave line short circuited at load end behaves as

View solution

Q. A (75 - J50) ohm load is connected to a coaxial of Z0 = 75 ohm at 10 GHz. The best method of matching is to connect

View solution

Q. The width of a radio beam from a 1 m diameter parabolic antenna at 1 GHz is about

View solution

Q. To couple a coaxial line to a parallel wire line it is best to use

View solution

Q. Assertion (A): A quarter wave transformer is used to match a resistive load to a transmission line.

Reason (R): A quarter wave transformer is a transmission line of quarter wave length.

View solution

Q. Assertion (A): Magnetron is generally used in n mode.

Reason (R): Frequency for π mode can be easily separated from adjacent modes.

View solution

Q. A balun should have

View solution

Q. Assertion (A): The velocity factor of a line is the ratio of wave velocity on the line to speed of light.

Reason (R): If the conductors of a line are immersed in a non magnetic insulating liquid, the wave velocity increases.

View solution

Q. The directivity in a receiving antenna

1. increases the intercept area in forward direction
2. reduces the noise picked up from other sources
3. provides a means of discriminating against undesired signals originating in directions other than in which the desired transmitter lies.

Which of the above statements are correct?

View solution

Q. Assertion (A): PIN diode can be used as attenuator and limiter.

Reason (R): PIN diode has a thin intrinsic layer.

View solution

Q. The bunching action which occurs in multicavity klystron amplifier can be represented by Applegate diagram

View solution

Q. The cut off wavelength in circular waveguide

View solution

Q. In Reflex Klystron oscillator the focussing electrode is at a high potential

View solution

Q. Consider the following statements:

1. Impedance of Gunn diode is about tens of ohms.
2. Impedance of Impatt diode is a few ohms.
3. Impedance of Impatt diode are of the same order.
4. Impedance of Impatt diode is more than that of Gunn diode.

Which of the above statement are correct?

View solution

Q. In high frequency circuits impedance matching can be done by

1. open circuited stubs
2. short circuited stubs
3. λ/4 transformer

Which of the above correct?

View solution

Q. The directive gain of a transmitting antenna is proportional to

View solution