Q. Roughly the time required for microwave cooking as compared to conventional cooking is

View solution

Q. If the minimum range of a radar is to be doubled, the peak power has to be increased by a factor of

View solution

Q. Which mode has the lowest cut off frequency in circular wave guides?

View solution

Q. Assertion (A): Klystron amplifiers use one or more intermediate cavities in addition to buncher and catcher cavity.

Reason (R): When one or more intermediate cavities are used the bandwidth can be increased.

View solution

Q. A wave Em cos (bx - ωt) is a backward wave.

View solution

Q. In a circular waveguide TE₂₁ mode has lowest cutoff frequency

View solution

Q. The number of TV channels which can be accommodated in a spectrum of 300 MHz is about

View solution

Q. The noise figure of multicavity klystron amplifier is very low

View solution

Q. Assertion (A): The velocity of electromagnetic waves on overhead lines and coaxial cables is the same.

Reason (R): Free space has an intrinsic impedance of 377 ohms.

View solution

Q. A cavity resonator is

View solution

Q. If antenna diameter is increased four times, the maximum range is increased by a factor of

View solution

Q. Assertion (A): Gunn diode is a transferred electron device.

Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.

View solution

Q. Atomic and molecular resonance is observed in many substances

View solution

Q. A reflex klystron oscillator is a

View solution

Q. Consider the following applications:

1. TV tuning
2. Active filter
3. Microwave frequency multiplication

In which of above can a varactor diode be used?

View solution

Q. Consider the following statements:

1. Dissipative attenuator has a fixed value of attenuation.
2. Reflective attenuator has a fixed value of attenuation.
3. Both dissipative and reflective attenuators are available only with fixed attenuation.
4. Both dissipative and reflective attenuators are available with either fixed or variable attenuation.

Which of the above are correct?

View solution

Q. Impedance inversion may be obtained with

View solution

Q. Power gain of a multicavity klystron amplifier is

View solution

Q. The expression HZ = C cos(Bx) cos(Ay)yz is for

View solution

Q. Assertion (A): Impedance matching can be done by using stubs.

Reason (R): A double stub is used for impedance matching when frequency of signal varies.

View solution