Q. A TE₁₀ rectangular waveguide is to be designed for operation over 25-35 GHz and the band centre is 1.5 times the cutoff frequency. The dimension of broadside is

View solution

Q. In a klystron amplifier the force on all electrons

View solution

Q. If load impedance ZL >> Z0, then

View solution

Q. The inductance of a twin feeder used to connect antenna to TV receiver is about

View solution

Q. Assertion (A): Impatt diode is an avalanche diode.

Reason (R): Avalanche breakdown phenomenon occurs when a p-n junction is reverse biased.

View solution

Q. A radar has a maximum range of 120 km. The maximum allowable pulse repetition frequency for unambiguous reception is

View solution

Q. In a line with finite attenuation

View solution

Q. The electric field in a TWT due to applied signal

View solution

Q. A 75 ohm line is first short terminated and minima locations are noted. Then the short is replaced by resistive load and minima location are again noted. If minima location are not altered and VSWR is 3, the value of resistive load is

View solution

Q. The word 'LORAN' means

View solution

Q. The duty cycle of a radar transmitter is equal to

View solution

Q. In a klystron amplifier the bunching effect

View solution

Q. Which of the following modes of transmission will not be supported by a rectangular waveguide?

View solution

Q. In a circular waveguide with radius r, the dominant mode is

View solution

Q. If 'a' is the width of rectangular wave guide and 'λ' is the wave length, then

View solution

Q. A parametric amplifier uses

View solution

Q. Assertion (A): Impatt diode can be used in both amplifiers and oscillators.

Reason (R): Impatt diode has a low resistance.

View solution

Q. Which one of the following can be used for amplification of microwave energy?

View solution

Q. At frequencies of 10 MHz and higher the impedance represented by ground is primarity

View solution

Q. A disadvantage of microstrip line as the connections of compared to strip line is that former

View solution