Q. Assertion (A): In TE₁₀ mode the cutoff frequency of rectangular waveguide is c/2a, where a is the broad dimension and c is velocity of light.

Reason (R): TE₁₀ mode is the dominant mode in rectangular waveguide.

View solution

Q. In which of the following devices can the operation be visualised in terms of a series feedback loops?

View solution

Q. The first and second subscripts in models of circular waveguides depict

View solution

Q. In which mode of circular waveguide does the attenuation continuously decrease as frequency is increased?

View solution

Q. In which mode of rectangular waveguide are all field components zero?

View solution

Q. A microstrip line has dielectric having relative permittivity ∈r. The effective dielectric constant is

View solution

Q. Oscillations are obtained from a reflex klystron only for combinations of anode voltage and repeller voltage that give a favourable transit time.

View solution

Q. The noise figure of klystron amplifier is about

View solution

Q. Which one of the following is true for EM wave propagation through rectangular waveguide of cross-section 2a x a

View solution

Q. In 8 cavity magnetron the π mode corresponds to a total phase shift equal to

View solution

Q. Satellite communication systems use the frequency band

View solution

Q. The characteristic impedance of a cable is about

View solution

Q. A TR (transmitter receiver) tube has

View solution

Q. A microwave connector should have high SWR.

View solution

Q. Assertion (A): A small section of high impedance line is equivalent to a series inductance.

Reason (R): A small section of a low impedance line is equivalent to a series resistance.

View solution

Q. Assertion (A): Bolometer is frequently used in microwave power measurement.

Reason (R): In a bolometer the input microwave power causes a change in resistance.

View solution

Q. The radiation resistance of a doublet antenna of length dl is proportional to

View solution

Q. Which of the following statements is not correct regarding modes of electromagnetic energy transmission?

View solution

Q. The usable bandwidth of ridge wave guide

View solution

Q. Assertion (A): In TE mode for rectangular waveguide.

Reason (R): In TM mode for rectangular waveguide.

View solution