Q. The most commonly used magnetron is

View solution

Q. The effect of earth's magnetic field on radiowaves is minimum when

View solution

Q. A line of characteristic impedance Z₀ branches into two line each with characteristic impedance Z₀. The refracted voltage is

View solution

Q. The resistance values of a PIN diode under positive bias and negative bias respectively are about

View solution

Q. A PIN diode can be used

View solution

Q. What is the numerical aperture an optical fiber when critical angle is 30°?

View solution

Q. A line of length slightly less than λ/4 and short circuited at far end behaves as

View solution

Q. In TE₁₀ mode of rectangular waveguide

View solution

Q. Reflection from the object to be measured is significant only when the wavelength is

View solution

Q. The speed at which axial electric field due to signal advances in a TWT is equal to

View solution

Q. Slotted line can be used for measurement of high frequencies

View solution

Q. In a waveguide the dielectric region is generally

View solution

Q. A line is excited by a 100 V, 200 ohm source and is terminated by 100 Ω resistance. If the voltage on line reaches steady value in 80 ns, the natural resonant frequency is

View solution

Q. A line of length slightly longer than λ/4 and open circuited at far end behaves as

View solution

Q. Klystron amplifier is not used to amplifier very weak microwave signals due to

View solution

Q. Which of the following modes in circular waveguides are circularly symmetric?

View solution

Q. Which of the following lines behaves as infinite line?

View solution

Q. A rectangular waveguide has two stubs each length λ/4 connected at the source end. The stubs are short circuted. Then

View solution

Q. Performance of a PIN diode switch is represented by

View solution

Q. As frequency is increased, the skin effect

View solution