Q. In a microwave resistor the wall thickness is made as small as possible to

View solution

Q. In a klystron amplifier the transit time of electron passing the gap in the cavity should be

View solution

Q. In a cable with ∈r = 4, the wave velocity is

View solution

Q. In a backward wave oscillator the efficiency

View solution

Q. Consider the following statements

1. Fading of signals is generally greatest near radio horizon.
2. Fading of signals is generally greatest in shadow zone.
3. Fading is small when a good optical path is present.

Which of the above statements are correct?

View solution

Q. The use of coaxial microwave line should be restricted to frequencies

View solution

Q. Generally the wall thickness of rectangular waveguide is

View solution

Q. Frequency range for satellite communication is

View solution

Q. For a given operating frequency a waveguide has more power handling capacity than a coaxial line.

View solution

Q. VSWR = Emax/Emin.

View solution

Q. Power monitor and reflectometer use the principle of

View solution

Q. A line slightly longer than λ/4 length and short circuited at far end behaves as

View solution

Q. A waveguide twist is used to change the plane of polarization.

View solution

Q. In a multicavity klystron amplifier the electron velocity of the order of

View solution

Q. At a frequency equal to cutoff frequency in a rectangular wave guide

View solution

Q. In a rectangular waveguide cutoff wavelength for TE₁₀ mode is 8 cm. Then cutoff wavelength for TE₂₀ mode is

View solution

Q. In a coaxial line

View solution

Q. If a and b are the width and height of rectangular wave-guide the cut off wavelength λc for TE₂₀ mode is equal to

View solution

Q. A TEM wave is incident normally on a perfect conductor. The E and H fields at boundary will respectively be

View solution