Question
a.
the characteristic impedance is less than that of two wire line
b.
the wave velocity is less than that of two wire line
c.
both (a) and (b)
d.
neither (a) nor (b)
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In a coaxial line
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a rectangular waveguide cutoff wavelength for TE₁₀ mode is 8 cm. Then cutoff wavelength for TE₂₀ mode is
View solution
Q. At a frequency equal to cutoff frequency in a rectangular wave guide
View solution
Q. In a multicavity klystron amplifier the electron velocity of the order of
View solution
Q. A waveguide twist is used to change the plane of polarization.
View solution
Q. A line slightly longer than λ/4 length and short circuited at far end behaves as
View solution
Q. Power monitor and reflectometer use the principle of
View solution
Q. VSWR = Emax/Emin.
View solution
Q. For a given operating frequency a waveguide has more power handling capacity than a coaxial line.
View solution
Q. Frequency range for satellite communication is
View solution
Q. Generally the wall thickness of rectangular waveguide is
View solution
Q. The use of coaxial microwave line should be restricted to frequencies
View solution
Q. Consider the following statements
1. Fading of signals is generally greatest near radio horizon.
2. Fading of signals is generally greatest in shadow zone.
3. Fading is small when a good optical path is present.
Which of the above statements are correct?
View solution
Q. In a backward wave oscillator the efficiency
View solution
Q. In a cable with ∈r = 4, the wave velocity is
View solution
Q. In a klystron amplifier the transit time of electron passing the gap in the cavity should be
View solution
Q. In a microwave resistor the wall thickness is made as small as possible to
View solution
Q. Which modes of circular wave guides have circular symmetry?
View solution
Q. In TE₁₀ mode the largest electric field in a rectangular wave guide, occurs
View solution
Q. In a reflex klystron the output frequency is determined primarily by resonant frequency of cavity.
View solution
Q. Consider the following statement:
SWR of a transmission line is infinite when the load is
1. a short circuit
2. a complex impedance
3. an open circuit
4. a pure reactance
Which of the above statements are correct?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
