Q. A colour monitor usign 16 bits at a resolution of 600 x 400 pixels needs a memory of

View solution

Q. Read the following statements as regards register pairs in microprocessor 8085

1. B represents B, C pair with B as high order register and C as low order register.
2. D represents D, E pair with D as high order register and E as low order register.
3. H represents H, L pair with H as high order register and L as low order register.

Which of the above statements are correct?

View solution

Q. The 8085 instruction 'PUSH PSW' belongs to the group

View solution

Q. Assertion (A): In C it is possible for functions to call themselves.

Reason (R): C makes use of 'Pointers'.

View solution

Q. In IC 74181 a sum greater than 15 leads to low carry out.

View solution

Q. Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

View solution

Q. The operations which occur most frequently in a computer are

View solution

Q. Assertion (A): A dynamic RAM chip has much smaller cell than a static RAM chip.

Reason (R): In dynamic RAM one bit of information is stored as the charge on a capacitor.

View solution

Q. Which of the following produces very wide drifts in clock frequency?

View solution

Q. For decimal numbe'r 13.5, the floating point representation in 4 byte excess 128 code is

View solution

Q. Read the following statements:

1. A μP generally interfaced to several memory chips and I/O devices
2. Address space provided by μP is partitioned into sub sets of addresses
3. Address map and address partition refer to different terms in address space

Which of the above are correct?

View solution

Q. The register set and instruction set of 8088 is similar to that of

View solution

Q. Assertion (A): In direct addressing the address of operand is specified in the instruction.

Reason (R): Direct addressing is also called absolute addressing.

View solution

Q. Assertion (A): In Fortran 77 the statement IMPLICIT INTEGER (A - E) identifies all variable name which begin with A, B, C, D, or E as being of integer type.

Reason (R): IMPICIT statement in Fortran 77 is an improvement over earlier versions of Fortran.

View solution

Q. Which of the following assembler directives in 8085 does not cause any memory location to be used μp?

View solution

Q. The storage capacity of DSDD disk and DSHD disk are

View solution

Q. Which of the following is also called Non volatile RAM?

View solution

Q. ALU 1C 74181 can accept two words each having

View solution

Q. Which of the following is not a legal subscript?

View solution

Q. The instruction MOV M, r in 8085

View solution