Q. Usual value of the resistance suitable for a wire resistance strain gauge is __________ ohms.

View solution

Q. Permanent set in a material is produced by subjecting it to

View solution

Q. The following is a typical anionic collector used in flotation.

View solution

Q. Which of the following test is used for distinguishing among dry oils, semi-drying oils and non drying oils ?

View solution

Q. The wet bulb temperature is lower in dry air than in wet air at the same temperature. A dry bulb thermometer registers a higher temperature than a wet bulb thermometer except at __________ percent relative humidity.

View solution

Q. The process of removal of scale formed during hot rolling of steel is termed as

View solution

Q. A psychrometer does not measure the __________ temperature of moist air.

View solution

Q. An ideal material for making cooking vessels should have

View solution

Q. The units of the rate constant for a second order reaction are

View solution

Q. The most serious manufacturing defect from fracture toughness point of view is

View solution

Q. Leakage in a cooking gas cylinder is detected by

View solution

Q. Which of the following is the most wear resistant grade of carbide used for the cutting tools?

View solution

Q. The ratio of mass of a neutron to that of an electron is about 1839. What is the ratio of the mass of a proton to that of an electron?

View solution

Q. The malleability of a material is the property by virtue of which it can be rolled or hammered into thin sheets. Which of the following materials has the maximum malleability ?

View solution

Q. Particle nature of cathode rays is proved due to the fact that they

View solution

Q. The most commonly used moderator in nuclear power plants is

View solution

Q. Babbit lining is used on brass/bronze bearings to increase the

View solution

Q. The heat of neutralisation remains constant, when there is a reaction between dilute solutions of strong

View solution

Q. Joining of thin foils is preferred to be done by

View solution

Q. Which of the following metals reacts violently with water ?

View solution