Question
a.
sec⁻¹. mole°.
b.
moles¹. sec⁻¹.
c.
moles⁻¹. sec¹.
d.
moles¹. sec¹.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The units of the rate constant for a second order reaction are
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The most serious manufacturing defect from fracture toughness point of view is
View solution
Q. Leakage in a cooking gas cylinder is detected by
View solution
Q. Which of the following is the most wear resistant grade of carbide used for the cutting tools?
View solution
Q. The ratio of mass of a neutron to that of an electron is about 1839. What is the ratio of the mass of a proton to that of an electron?
View solution
Q. The malleability of a material is the property by virtue of which it can be rolled or hammered into thin sheets. Which of the following materials has the maximum malleability ?
View solution
Q. Particle nature of cathode rays is proved due to the fact that they
View solution
Q. The most commonly used moderator in nuclear power plants is
View solution
Q. Babbit lining is used on brass/bronze bearings to increase the
View solution
Q. The heat of neutralisation remains constant, when there is a reaction between dilute solutions of strong
View solution
Q. Joining of thin foils is preferred to be done by
View solution
Q. Which of the following metals reacts violently with water ?
View solution
Q. A steam carraying pipeline is insulated with two layers of insulating materials with the inferior insulation material forming the inner part. If the two insulating layers are interchanged, the heat conducted will
View solution
Q. Damage to metal surface by mechanical action is called
View solution
Q. The escape velocity of a body on earth which is independent of its mass is about __________ km/second.
View solution
Q. A reduction in thermal resistance during heat transfer does not occur in the
View solution
Q. Unit of viscosity in CGS system is
View solution
Q. Shaft/rotor speed is most accurately measured by a
View solution
Q. __________ test determines the yield strength, Young's modulus of elasticity, percentage reduction in area & percentage elongation of a material.
View solution
Q. The rolling process can not be used to produce
View solution
Q. Co-efficient of performance of a Carnot cycle refrigerator operating between - 23°C and + 27°C is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
