Question
a.
convection heat transfer by stirring the fluid and cleaning the heating surface.
b.
conduction heat transfer by reduction in the material thickness and increase in the thermal conductivity.
c.
radiation heat transfer by increasing the temperature and reducing the emis-sivity.
d.
none of these.
Posted under Basic Chemical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A reduction in thermal resistance during heat transfer does not occur in the
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Unit of viscosity in CGS system is
View solution
Q. Shaft/rotor speed is most accurately measured by a
View solution
Q. __________ test determines the yield strength, Young's modulus of elasticity, percentage reduction in area & percentage elongation of a material.
View solution
Q. The rolling process can not be used to produce
View solution
Q. Co-efficient of performance of a Carnot cycle refrigerator operating between - 23°C and + 27°C is
View solution
Q. Presence of nickel & chromium in steel does not raise its
View solution
Q. Hot extrusion process is not used for making
View solution
Q. Addition of __________ to steel does not help in improving its machinability.
View solution
Q. Quartz is a __________ material.
View solution
Q. A solution which resists change in its pH value on addition of acid/alkali is called the __________ solution.
View solution
Q. Pick out the wrong statement.
View solution
Q. The bolt is subjected to __________ when the nut is tightened by putting the washer beneath it.
View solution
Q. Which of the following is not categorised as the ore agglomeration process ?
View solution
Q. With increase in temperature, the surface tension of water
View solution
Q. Laser is a device to produce
View solution
Q. Addition of small amount of __________ to grey cast iron is done to produce nodular grey cast iron.
View solution
Q. Minimum thermal efficiency of a steam boiler may be around __________ percent
View solution
Q. The temperature at which the magnetic property of iron disappears (i.e., it becomes non-magnetic) and its electrical conductivity & specific heat also changes, is called the 'Curie point', which is __________ °C.
View solution
Q. Fatigue limit improvement by over stressing the metal by successively increasing the load is called coaxing. In fatigue failure, the material fails
View solution
Q. Principal alloying elements of cast tool alloys which have very high wear resistance & high temperature strength are
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!