Q. A reduction in thermal resistance during heat transfer does not occur in the

View solution

Q. Unit of viscosity in CGS system is

View solution

Q. Shaft/rotor speed is most accurately measured by a

View solution

Q. __________ test determines the yield strength, Young's modulus of elasticity, percentage reduction in area & percentage elongation of a material.

View solution

Q. The rolling process can not be used to produce

View solution

Q. Co-efficient of performance of a Carnot cycle refrigerator operating between - 23°C and + 27°C is

View solution

Q. Presence of nickel & chromium in steel does not raise its

View solution

Q. Hot extrusion process is not used for making

View solution

Q. Addition of __________ to steel does not help in improving its machinability.

View solution

Q. Quartz is a __________ material.

View solution

Q. A solution which resists change in its pH value on addition of acid/alkali is called the __________ solution.

View solution

Q. Pick out the wrong statement.

View solution

Q. The bolt is subjected to __________ when the nut is tightened by putting the washer beneath it.

View solution

Q. Which of the following is not categorised as the ore agglomeration process ?

View solution

Q. With increase in temperature, the surface tension of water

View solution

Q. Laser is a device to produce

View solution

Q. Addition of small amount of __________ to grey cast iron is done to produce nodular grey cast iron.

View solution

Q. Minimum thermal efficiency of a steam boiler may be around __________ percent

View solution

Q. The temperature at which the magnetic property of iron disappears (i.e., it becomes non-magnetic) and its electrical conductivity & specific heat also changes, is called the 'Curie point', which is __________ °C.

View solution

Q. Fatigue limit improvement by over stressing the metal by successively increasing the load is called coaxing. In fatigue failure, the material fails

View solution