Q. Out of the following, the lowest packing of atoms exists in __________ crystal lattice structure.

View solution

Q. Cadmium in zinc leach liquor is removed by cementation using

View solution

Q. Lead is poured into the joint between two- __________ pipes.

View solution

Q. The concentration of (H⁺) ions is 4 x 10⁻⁵ in a solution. Then pH of the solution will be (Given log 4 = 0.6 )

View solution

Q. Age hardening is connected with

View solution

Q. With decrease in the grain size of a material, its creep resistance

View solution

Q. __________ rubber is generally used for making 'O' rings used for vacuum sealings.

View solution

Q. Gas turbine normally employs a constant __________ cycle.

View solution

Q. Which of the following relationships is correct for relating the three elastic constants of an isotropic elastic material (where, E = Young's modulus, G = Modulus of rigidity or shear modulus v = Poisson's ratio) ?

View solution

Q. Electrostatic separation of minerals from each other is based on their differences in the following property.

View solution

Q. Natural water contains approximately __________ percent of heavy water.

View solution

Q. The minimum temperature to which the water can be cooled in a cooling tower is the __________ temperature of air.

View solution

Q. In electrical resistance welding, distortion results from the use of improper

View solution

Q. The conventional mechnical transducer, which converts pressure signal to displacement signal is

View solution

Q. Pick out the wrong statement.

View solution

Q. Austempering of steel requires.it to be heated to 875°C followed by sudden cooling to 250-525°C, thereby changing austenite to

View solution

Q. A compact estimate about the amount of materials handling between various work stations is obtained from the

View solution

Q. __________ can replace tungsten in high speed steel.

View solution

Q. Production of one ton of paper in Indian paper industry consumes about __________ kWh of electricity.

View solution

Q. Fatigue strength of a material can not be increased by

View solution