Q. The hardness of the lathe bed material is measured by the

View solution

Q. RADAR is

View solution

Q. In the floatation process, pine oil is used as the

View solution

Q. With increasing carbon percent in steel beyond 0.8%, its ultimate tensile strength (UTS) and __________ is not affected.

View solution

Q. Unit molar solution of __________ is the best conductor of electricity.

View solution

Q. A coal with high __________ content will ignite most easily.

View solution

Q. The weight of a body at the centre of the earth is

View solution

Q. For the same heat input & compression ratio, efficiency of Otto cycle is higher than that of diesel cycle, because in Otto cycle.

View solution

Q. The single most imortant requirement for a turbine blade material is

View solution

Q. Pick out the correct statement.

View solution

Q. Ageing of steel refers to the

View solution

Q. When dry bulb temperature & wet bulb temperature of moist air is the same, it means that the

View solution

Q. When metals are heated to high temperature, their __________ increases in general.

View solution

Q. A friction lighter is normally used for lighting gas welding torch, because of the reason that

View solution

Q. Semi-conductors normally employ __________ bonding.

View solution

Q. High endurance limit of carburised machine parts is because of the fact that carburisation

View solution

Q. In __________ process, there is an increase in entropy with no degradation of energy.

View solution

Q. Which of the following is categorised as the plastic welding ?

View solution

Q. In spite of large heat transfer co-efficients in boiling liquids, fins are used advantageously, where the entire surface is exposed to __________ boiling.

View solution

Q. Other parameters remaining same, the recrystallisation temperature of an alloy is lowered, when

View solution