Q. Factor of safety in machine design is defined as the ratio of ultimate stress to __________ stress.

View solution

Q. Out of the following, the __________ pipe has the least corrosion resistance.

View solution

Q. With increase in steam pressure, its specific volume decreases

View solution

Q. Which of the following rays has the least wavelength?

View solution

Q. Hydrocyclone is a

View solution

Q. Direct conversion of thermal energy to electrical energy is facilitated by the

View solution

Q. The minimum carbon content in steel should be __________ percent for it to respond to a hardening treatment.

View solution

Q. Angular displacement can be measured suitably by a

View solution

Q. Minimum temperature upto which water can be theoretically cooled down in the cooling tower by evaporative cooling is equal to the __________ temperature of air.

View solution

Q. Heat transfer to the water wall in a high pressure water wall type boiler furnace is mainly by

View solution

Q. Wood is a/an __________ material.

View solution

Q. Pick out the wrong statement.

View solution

Q. Use of flux during soldering is done to

View solution

Q. Resilience of a bolt can be increased by increasing its

View solution

Q. A boy weighing 110lb climbs up a 50 ft high vertical destination in 100 seconds. Horse power of the boy is __________ hp.

View solution

Q. Endurance is a measure of fatigue limit of a metal. Fatigue crack in nitrided machine parts originates

View solution

Q. Carbon percentage in high speed steel tool material is 0.6 to 1.0. The hardness of carbon tool steels is increased, when it is alloyed with

View solution

Q. Draft allowance given to patterns is for

View solution

Q. Which of the following welding processes employs the highest welding temperature ?

View solution

Q. The best criterion for analysing an economic investment is the

View solution