Q. Carbon percentage in high speed steel tool material is 0.6 to 1.0. The hardness of carbon tool steels is increased, when it is alloyed with

View solution

Q. Draft allowance given to patterns is for

View solution

Q. Which of the following welding processes employs the highest welding temperature ?

View solution

Q. The best criterion for analysing an economic investment is the

View solution

Q. Deformation band is absent in materials having __________ lattice crystal structure.

View solution

Q. Out of the following, the rays having the lowest wavelength is the

View solution

Q. A fine grained grinding wheel should not be used for grinding __________ materials.

View solution

Q. What is the effect on the performance of the economiser in the thermal power plant boiler, if the feed water temperature is very low due to preheaters being out for repairs or starving of steam supply ?

View solution

Q. A good abrasive

View solution

Q. Out of the following, __________ pipe is the least corrosion resistant.

View solution

Q. In order to protect the aquatic creatures, the dissolved oxygen content in fresh water stream should never be less than __________ PPm.

View solution

Q. For which pair of the fuel gases, calorific value (C.V.) of one fuel is almost double that of the other on volume basis (i.e., kcal/Nm³) while the C.V. is same on weight basis (i.e., kcal/kg) ?

View solution

Q. Sheardising process is used for

View solution

Q. Mechanism/phenomenon involved in the improvement of fatigue strength of a material by shot peening is the

View solution

Q. Springs are not made of

View solution

Q. Pick out the wrong statement.

View solution

Q. Monazite deposits constitute an important source for the following metal.

View solution

Q. α-rays are

View solution

Q. The bulk modulus of a material with Poisson's ratio of 0.5 is equal to

View solution

Q. Compression ratio of an I.C. engine is the ratio of the

View solution