Q. Softening of hardned steel is done by its

View solution

Q. Air/fuel ratio by weight for combustion of methane with theoretical quantity of air will be about

View solution

Q. Which of the following alloying elements is present in maximum percentage in high speed steel.

View solution

Q. The delivery pressure of boiler feed water pump compared to the boiler steam pressure is

View solution

Q. The excess air required for the combustion of pulverised coal is of the order of about __________ percent.

View solution

Q. Pick out the wrong statement.

View solution

Q. __________ of austenite decreases the hardenability in steel.

View solution

Q. A jig is used while __________ a hole.

View solution

Q. Which of the following is not a cupro-nick-el alloy ?

View solution

Q. Electrochemical corrosion occurs

View solution

Q. The ability of tool steel to resist softening at high temperatures is termed as __________ hardness.

View solution

Q. Improvement in mechanical properties of metals in its hot working is due to the grains

View solution

Q. Young's modulus of elasticity of a material is the slope of the initial linear portion of the stress-strain curve. It decreases ap-preciablyby

View solution

Q. Batch process is preferred over continuous process, when the

View solution

Q. Which of the following is a permanent fastening?

View solution

Q. Hot & cold working of material causes its __________ deformation.

View solution

Q. The ratio of thermal & electrical conductivity is same for all the metals at the same temperature ; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K)

View solution

Q. In a fuel cell, chemical energy is converted into

View solution

Q. Shock resisting steels should possess high

View solution

Q. Fatigue life is expected to increase by

View solution