Q. __________ of austenite decreases the hardenability in steel.

View solution

Q. A jig is used while __________ a hole.

View solution

Q. Which of the following is not a cupro-nick-el alloy ?

View solution

Q. Electrochemical corrosion occurs

View solution

Q. The ability of tool steel to resist softening at high temperatures is termed as __________ hardness.

View solution

Q. Improvement in mechanical properties of metals in its hot working is due to the grains

View solution

Q. Young's modulus of elasticity of a material is the slope of the initial linear portion of the stress-strain curve. It decreases ap-preciablyby

View solution

Q. Batch process is preferred over continuous process, when the

View solution

Q. Which of the following is a permanent fastening?

View solution

Q. Hot & cold working of material causes its __________ deformation.

View solution

Q. The ratio of thermal & electrical conductivity is same for all the metals at the same temperature ; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K)

View solution

Q. In a fuel cell, chemical energy is converted into

View solution

Q. Shock resisting steels should possess high

View solution

Q. Fatigue life is expected to increase by

View solution

Q. Specific __________ is a dimensionless quantity.

View solution

Q. __________ is not used as the control rod material in a nuclear reactor.

View solution

Q. Superheated vapour behaves like

View solution

Q. Which of the following is not an ore of iron ?

View solution

Q. Which is the most lethal weapon ?

View solution

Q. Reynolds number of a fluid flowing in a circular pipe is 10000. What will be the Reynolds number when the fluid velocity is decreased by 30% & the pipe diameter is increased by 30% ?

View solution