Q. Baffles in the shell side of a shell and tube heat exchanger

View solution

Q. Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is

View solution

Q. The unit of heat transfer co-efficient in SI unit is

View solution

Q. The number of kg vaporised per kg of steam fed to the evaporator is defined as

View solution

Q. Pick out the wrong statement.

View solution

Q. Economy of a multiple effect evaporator is not influenced much by the

View solution

Q. Increasing the liquor level in the evaporator results in the

View solution

Q. Pick out the wrong statement.

View solution

Q. Convective heat transfer co-efficient in case of fluid flowing in tubes is not affected by the tube length/diameter ratio, if the flow is in the __________ zone.

View solution

Q. The actual temperature drop across the heating surface in an evaporator depends on the

View solution

Q. Which of the following is not used as a medium for high temperature heating ?

View solution

Q. Presence of a non-condensing gas in a condensing vapour

View solution

Q. The average heat transfer co-efficient for laminar film condensation on vertical surface is inversely proportional to (where, ΔT = Temperature drop across condensate film )

View solution

Q. Bulk of the convective heat transfer resistance from a hot tube surface to the fluid flowing in it, is

View solution

Q. Which of the following is concerned with both heat and mass transfer ?

View solution

Q. A backward feed multiple effect evaporator is better than forward feed for concentrating cold feed, because it provides

View solution

Q. A 10 cm diameter steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer co-efficient of 0.8 W/m².°C for heat transfer from surface to the surroundings. Neglect wall resistance of the pipe and film resistance of steam. If the insulation thickness is 2 cms, the rate of heat loss from this insulated pipe will be

View solution

Q. Fouling factor

View solution

Q. In case of vertical tube evaporator, with increase in liquor level, the overall heat transfer co-efficient

View solution

Q. The steam ejector is used to

View solution